This page provides information on the latest CPE firmware releases, including new features, performance improvements, and important fixes.

1.3.2+20260422.0

Fixed an issue in High Availability setups that prevented certain network interfaces from being created correctly.

1.3.1+20260408.0

CPE local UI and admin CLI toggle: Added the ability to enable or disable the CPE local UI and admin CLI as needed.
CPE serial number as default password: The default password for the CPE’s local UI and admin CLI is now set to the CPE serial number.
BLR-EDGE-1200 support: Added support for the BLR-EDGE-1200 device.
Bug fixes and security updates: This release includes bug fixes and security patches to improve overall stability and security.

SD‑WAN tunnel overlay v3 support: Support for the new overlay architecture is now available. This capability depends on POP upgrades, which will roll out regionally throughout the first half of 2026.
Block‑circuit compatibility for upcoming data‑metering feature: Added foundational support for block circuits in preparation for the new data‑metering feature launching in the first half of 2026.
Speed test reliability improvements Resolved several issues affecting speed test accuracy and consistency.

Circuit Speed Test: You can now run a speed test on just one circuit or on all of them at the same time.

Tunnel Protocol v3: Enhanced Tunnel Overlay now reduces background data, improving performance and cutting bandwidth usage. POP updates are required and will be deployed throughout 2025 and early 2026.
Site Configuration: You can now switch a site's CPE between Standard and High Availability service options without having to set up a new site.
Fixed an issue where devices on your local network(LAN Clients) sometimes appeared online even after they’d been disconnected for many days.
Fixed an issue where the wireless connection (WAN 4 on the EDGE 800W) would disconnect and reconnect after making configuration changes to the site.
Fixed an issue where switching a connection to use expansion ports (EXP) from the CPE’s local web app didn’t restore internet access.
Various bug fixes and enhancements to ensure better overall reliability.

Fixes an issue introduced in version 1.1.0+20250616.0 that blocked access to the Local UI that is accessed through the LAN port on the CPE.

Wi-Fi Access Point (BLR-EDGE-800W only): You can now configure both a primary and a guest Wi-Fi network. Only the primary Wi-Fi Network will access to your LAN devices giving you more flexibility and better control over your wireless setup.
Device Access Control (BLR-EDGE-800W only): Limit which devices can connect to your primary local network by filtering them based on their MAC address.
Port Forwarding (BLR-EDGE-800W only): Enables advanced networking configurations, allowing specific devices or applications to be accessible from outside your network.
Static IP Leases (BLR-EDGE-800W only): Ability to assign static private IP address to devices on the private LAN Network.
LAN Clients (BLR-EDGE-800W only): Ability to see wired and wireless devices that are connected to your primary and guest networks
Circuit Reset Diagnostics Job: Adds support for a diagnostics test to turn the circuit interface on and off.
Various bug fixes and enhancements to ensure better overall reliability.

Enhance the reliability of retrieving IMEI and ICCID data on sites with BLR-EDGE-800W CPE.

Fixes a memory leak
Fix ixgbe driver on BLR-108. The driver was unable to auto negotiate to 10/100Mbps

5G/LTE Support (BLR-EDGE-800W only): Adds 5G/LTE support, allowing for faster and more flexible wireless connectivity.
ARP Diagnostics Test: A new diagnostic test that helps identify and troubleshoot network issues by retrieving the ARP (Address Resolution Protocol) table, making it easier to detect connectivity problems.
Device Interface Statistics Diagnostics Test: A new diagnostic test that helps identify and troubleshoot network issues by collecting and reporting interface statistics such as tx errors, rx errors, collisions, speed, MAC Address and IP address